Squid configuration directive clientside_tos

Available in: 4   3.5   3.4   3.3   3.2   3.1   3.0  

For older versions than 3.3 see the linked pages above

Configuration Details:

Option Name:clientside_tos
Replaces:
Requires:
Default Value:none
Suggested Config:

	Allows you to select a TOS/DSCP value for packets being transmitted
	on the client-side, based on an ACL.

	clientside_tos ds-field [!]aclname ...

	Example where normal_service_net uses the TOS value 0x00
	and good_service_net uses 0x20

	acl normal_service_net src 10.0.0.0/24
	acl good_service_net src 10.0.1.0/24
	clientside_tos 0x00 normal_service_net
	clientside_tos 0x20 good_service_net

	Note: This feature is incompatible with qos_flows. Any TOS values set here
	will be overwritten by TOS values in qos_flows.

	The TOS/DSCP byte must be exactly that - a octet value  0 - 255, or
	"default" to use whatever default your host has.
	Note that only multiples of 4 are usable as the two rightmost bits have
	been redefined for use by ECN (RFC 3168 section 23.1).
	The squid parser will enforce this by masking away the ECN bits.

	This clause only supports fast acl types.
	See http://wiki.squid-cache.org/SquidFaq/SquidAcl for details.

 

Back

 

Introduction

Documentation

Support

Miscellaneous

Web Site Translations

Mirrors